Troy-Bilt Flurry 1400 Manual Del Operador página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.
Attach the upper handle to the mid handle using one
carriage screw and handle knob on each side. See Figure
3-3.
NOTE: Make sure the cord is routed behind the handle
assembly.
Carriage Bolt
Handle Knobs
3.
Ensure that the cord retainer is on the mid handle's
crossbar. Refer to Figure 3-2. Place the mid and upper
handles onto the lower handle. See Figure 3-4.
Carriage Bolt
Handle Knobs
4.
Insert wing knobs and carriage bolt and tighten to secure
upper handle and mid handle to the lower handle. See
Figure 3-4.
8
S
2— A
ection
SSembly
Carriage Bolt
Figure 3-3
Carriage Bolt
Figure 3-4
& S
-U
et
p
5.
Secure motor cord to cable guide. See Figure 3-5.
NOTE: The motor cord runs behind the upper handle.
Cable Guide
Motor Cord
Figure 3-5
Chute Assembly
1.
Remove the four screws securing the front cover to the
auger housing. Remove the front cover and the chute. See
Figure 3-6.
Chute Assembly
Front Cover
Screw
Figure 3-6
2.
Remove the wing knob, bell washer and bolt from the left
side of the chute. See Figure 3-7.
3.
Pivot the upper chute upwards and over the lip and the top
of the lower chute.
4.
Reinstall the wing knob, bell washer and bolt.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido