Publicidad
Idiomas disponibles
Idiomas disponibles
high Density Camshelving
7. Screw in two Stainless Steel Leveling Feet (See
Fig. 3) to the back of each unit. (As shown in
Fig. 5)
8. Place one Track Rail Stationary Plate Cap, with
the curved ends facing down to the base of the
foot, onto a Stainless Steel Leveling Foot. Add a
⁄
" (1,3 cm) Hex Nut. (See Fig. 4) Repeat for the
1
2
2nd Stainless Steel Leveling Foot. Screw each
one into the posts on the front of the unit. (See
Fig. 5) imPortant: Do not adjust or tighten at
this time.
Fig. 5
B
A
9. Place a Stationary Unit at each end of the track with the front facing the tracks. Adjust all of
the leveling feet so the unit sits flat on the floor surface. Slide the Track Rail Stationary End
Plate underneath the Track Rail Stationary Plate Cap (See Fig. 6). Secure in place and tighten
the
⁄
" (1,3 cm) Hex Nuts with a Crescent Wrench. This secures the Stationary Unit to the
1
2
tracks. (See Fig. 7).
Fig. 6
Stationary Unit, Front
Track Rail Stationary
Plate Cap
Track Rail Stationary
End Plate
All specs are subject to change without prior notice.
storage system assembly instructions
®
Fig. 3
A
Back Leveling Foot
Fig. 4
B
Front Leveling Foot
½" Hex Nut
Track Rail Stationary
Plate Cap
B
A
Fig. 7
⁄
" Hex Nut
1
2
D U R A B I L I T Y T H A T M A K E S A D I F F E R E N C E
© 2009 Cambro Manufacturing Company 5801 Skylab Road, Huntington Beach, CA 92647-2056, U.S.A.
telephone 714 848 1555 toll Free 800 854 7631 Customer service hot line 800 833 3003 Printed in USA
10. Assemble High Density Camshelving Mobile Units per instructions included in each kit.
Carefully lift and place each High Density Mobile Camshelving Unit (requires 2 people) onto
the tracks, ensuring the casters roll smoothly on each raised Track Guide.
Track Guide
11. Finish by adding Shelf Plates to Stationary and Mobile Units.
maximUm Weight Bearing CaPaCity
Camshelving stationary Units
24" (61 cm) Wide x 36" (91 cm), 42" (107 cm),
48" (122 cm) Long x 64" (163 cm) or 72" (183cm) High
800 lbs. per shelf
3200 lbs. per unit
high Density Camshelving mobile Units with high Density Casters
750 lbs. (340 kg) per unit.
Warning:
Do not exCeeD maximum weight bearing capacity.
general manufacturer's Warranty
Cambro warrants to the original buyer a three-year pro-rated guarantee. If product proves
defective during this time, Cambro grants a pro-rated credit of the original price toward
replacement product. The warranty applies on all Cambro products only when used under
normal food service industry conditions.
Cleaning and maintenance
Wipe clean with damp cloth.
CAUTION: Two people are required to lift
Mobile Unit onto Track Guide.
®
UMHDTK
2
Publicidad
