Operation; General; Gmhd-2Pt Models - Hatco GLOMAX GMHD Serie Instrucciones Originales

General

Use the following procedures to operate the GLOMAX
Display Case.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.

GMHD-2PT Models

Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See
the SPECIFICATIONS section for details.
2. For humidity, fill the water pan with water.
• Periodically check the water level in the water pan to
ensure constant humidity inside the unit. If the water
level is low then refill the water pan.
• If humidity is not desired then leave the water pan empty.
Do NOT operate unit without water pan installed.
3. Move the Power I/O (on/off) switch to the I (on) position.
4. Turn the heat control to the desired temperature setting.
The temperature range is from 28°C (82°F) to 85°C (185°F).
5. Allow unit 30 minutes to reach operating temperature.
Shutdown
Perform the following steps for shutdown of all models.
1. Move the Power I/O (on/off) switch on the base to the O
(off) position.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
Form No. GMHDCEM-0918
Heat Control Knob
Heated
®
Sliding
Door
Heat Control Knob
Control Panel–GMHD-2PT Models
7

OPERATION

Power I/O (on/off)
Switch
Water Pan
Heated Display Case
Power I/O (on/off)
Switch