HQ-Power MICW70 Manual Del Usuario página 5

6. Use
Transmitter
• Place the transmitter in a suitable location (see safety instructions). Mounting brackets to mount
the transmitter in a 19" rack are included.
• Plug the power adapter in the [L] and plug the adapter in the mains.
• Connect the audio outputs to an external audio source e.g. CD-mixer (not incl.) using the included
audio cables. When applicable, connect the audio outputs to another device.
• Screw the included antenna on the antenna connector [H].
• Switch on the transmitter with the power switch [A].
• A headphone (not incl.) can be connected to the transmitter [B] when desired. The output volume
of the headphone jack can be set with the rotary knob [C].
• Set the output channel/frequency using the pushbuttons [G]. Press the set-button to enter set-up
mode. The frequency starts flashing. Use the up- or down button to select a new frequency. Note
that the channel number automatically changes when the frequency changes. Press the set-button
again to save changes and exit set-up-mode. Note that set-up automatically exits after ±10s when
no input is detected.
• To set the volume limiter, set the maximum allowed volume, press the set-button followed by the
menu-button until the LIM-indication [4] flashes. Use the up- or down button to switch the limiter
on or off (ON = ). When switched on, the volume will be limited to the set volume. Press the set-
button again to save changes and exit set-up-mode.
• The transmission power can be set to 3 different levels. To do this, press the set-button followed
by the menu-button until the antenna-indication [3] flashes. Use the up- or down button to set
the power:
• Set the gain control switch [K] at the back of the transmitter to 0dB or +10dB to set the input
gain.
• The strength of the input signals is indicated on the display [1] & [2].
input jack
Receiver
• See §9 for instructions on battery installation.
• Switch the receiver on by rotating the power ON/OFF & volume control button [O] clockwise.
• Use the balance control ring [P] to control the balance. When the bulge is lined up with the notch
(see image below), audio left and right are symmetrical.
• Set the channel/frequency to the same value as the transmitter. To do this, press and hold either
the up ([S]) or down ([T]) button until the channel/frequency indicator [12] flashes. Use the set
button [R] to choose between channel or frequency display and use the up ([S]) or down ([T])
button to select a new channel or frequency. Set-up automatically saves and exits after ±10s.
• Press the set-button [R] to scroll through the different settings (MIX [7], LIM [8], SQL [14] and
EQ [15]. The current setting flashes.
o MIX [7]: press up ([S]) or down ([T]) to switch mixed mode on (=
background information).
o LIM [8]: to set the volume limiter, set the maximum allowed volume and press up ([S]) or
down ([T]) to switch mixed mode on ( ) or off.
00 (09/01/2009)
MICW70
indication transmitting power
unbalanced
5
≤ 10dBM
≤ 15dBM
≤ 20dBM
input connector
) or off (see §7 for
balanced
®
Velleman