Engine Maintenance; Storage; Protecting The Pump; Storing The Engine - Speed Clean 020238-1 Manual Del Operario

ENGINE MAINTENANCE

See the engine operator's manual for instructions on how
to properly maintain the engine.
CAUTION
Avoid prolonged or repeated skin contact with used
motor oil.
• Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
• Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
1. Flush detergent siphoning tube/filter by placing filter
into a pail of clean water while running pressure
washer in low pressure mode (adjustable nozzle in
forward position). Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug.
3. Place the spray gun, nozzle extension and high pressure
hose in the accessory storage bag.
4. Empty pump of all pumped liquids by pulling recoil handle
about 6 times.This should remove most liquid in pump.
5. Use PumpSaver to prevent corrosion build up and
freezing of pump.
6. Store unit in a clean, dry area.
SpeedClean™ 2000 PSI Pressure Washer

Protecting the Pump

To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Read and follow all
instructions and warnings given on the PumpSaver container.
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
• Freeze damage is not covered under warranty.
• Always wear eye protection when using PumpSaver.
• Protect surfaces from dripping PumpSaver.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.

STORING THE ENGINE

See the engine operator's manual for instructions on how
to properly prepare the engine for storage.
16
CAUTION
render your unit inoperable.
CAUTION
Read and follow all cautions and warnings on the
PumpSaver can label.
CAUTION
PumpSaver will drip from pump after treatment and
will stain wood and concrete.