Confirm Proper Operation; Operating Sequence - KALLISTA H2 Serie Guia De Instalacion

Heater
On/Off
Power
On/Off
Lighted User Keypad
13. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully
counterclockwise.
Fill the whirlpool to a water level at least 2" (5 cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.

14. Operating Sequence

NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running. The heater will disengage at higher temperatures exceeding 104°F (40°C).
IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and
remote control.
Press the power icon to turn on the whirlpool. The whirlpool will start at medium flow.
Increase or decrease the water flow by pressing either the up or down arrow icons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow,
and counterclockwise to increase the air flow.
Press the heater icon to turn the heater off and back on. When illuminated, the indicator light shows
that the water temperature will be maintained up to 104°F (40°C).
Press the power On/Off icon a second time to turn the whirlpool off.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
1019455-2-D
Heater Indicator Light
Increases
Flow
Indicator Bar -
Shows water
flow volume
Decreases
Flow
Turn the jet trim
clockwise to
decrease the flow.
Turn the jet trim
counterclockwise to
increase the flow.
12 Kallista