Preparing Fruits And Vegetables For Juicing; Cleaning And Maintenance - Aigostar 8433325503109 Manual Del Usuario

GB

PREPARING FRUITS AND VEGETABLES FOR JUICING

● Wash fruits and vegetables.
● Peel fruits that have inedible skins such as citrus fruits,
pineapple, melons, etc.
● Pit all fruits with hard seeds or stones such as peaches,
cherries, etc.
● Most fruits and vegetables such as apples, carrots and
cucumbers will not need to be cut. If the pieces are too big for
the feed tube, slice the fruit or vegetables before starting to
juice.
USING YOU PRODUCT
1.Plug the appliance into the mains socket.
2.Set the control knob to the desired speed depending on the
type of fruit or vegetable that is being juiced.
● low speed, soft fruit or vegetable such as berries, cucumber,
tomatoes, etc.
● high speed, harder fruit or vegetables such as apples, celery
carrots, etc. Should be juiced at high speed.
3.Lift the food pusher out of feed tube and drop food into the
feed tube. Push through by inserting the pusher and pressing
firmly.
● NOTE: To extract the maximum amount of juice, please push
the food pusher down SLOWLY.
● Do not operate the appliance continuously for more than 40
seconds.
4.The juice will flow into the juice jug and pulp will accumulate
in the pulp container.
● If the pulp container is full, empty it before continue juicing.
Turn off and unplug the appliance from the mains socket.
Unlock the cover and then remove the pulp container. Empty
the pulp container. Replace the pulp container by sliding it into
05
position. Lock the cover and then plug the appliance into the
mains socket. Turn the control knob to the desired speed.
5.When the juicing is finished, turn the control knob to the 0
position to turn off the appliance.

CLEANING AND MAINTENANCE

Warning：Always turn off and unplug the
appliance before cleaning.
Disassembling the juice extractor
1.Remove the pusher from the feed tube.
2.Pull up the locking handle and then pull it away from the
recesses of the cover to unlock the cover.
3.Remove the cover.
4.Carefully remove the sieve by pulling up its rim. Be careful
not to touch the blades in the bottom of the sieve.
5.Remove the juice collector.
6.Remove the filter and juice jug.
Cleaning
Clean the base with s damp cloth. Never immerse the base in
water or any other liquid.
Wash all removable parts in warm soapy water. Rinse and dry
thoroughly.
Clean the sieve with a small nylon brush (not supplier).
WARNING: Please take care
to clean the sieve. The
blades at bottom are very
SHARP .
GB
06