Philips HD 3410-12 Manual Del Usuario página 4

English
Important
• Read the instructions for use together with the illustrations (pages 3 and 34) before using
the appliance.
• Before connecting the appliance check that the voltage indicated on the type plate
corresponds to the mains voltage in your home.
• Be careful when moving the appliance. First disconnect from the mains power and allow it to
cool down.
• If the appliance is covered there is a risk of fire. Do not dry laundry on the heater.
• This heater is filled with a precise quantity of special oil. If leakage occurs and for all repairs
requiring opening of the oil container contact your Philips dealer or an authorised Philips
Service Centre.
• Do not place the heater against or under inflammable objects. Allow a free space of at least
50 cm (approx. 20") to furniture, curtains etc.
• The heater must not be located below a wall socket.
• Keep the mains cord at a safe distance from the hot parts of the appliance.
• For your own safety and that of others: water and electricity are a dangerous combination!
Do not use the heater in the neighbourhood of a bath, shower or swimming pool.
• Use the heater only in a vertical position.
• Always remove the full length of mains cord from the mains cord storage before switching
on.
• Connect the appliance to an earthed wall socket.
• All installation and wiring must comply with current IEE regulations.
• It may happen, especially if both knobs (A) and (B) are in "on" position and another
electrical device is switched on as well, that a fuse or circuit breaker cuts off the mains
power. In such a case, the fuse or the circuit breaker may not be able to handle high
electrical power.
You may connect one of the involved appliances to another circuit (employing another fuse
or circuit breaker) or have the electrical installation revised by an authorized electrician.
- For United Kingdom (240 V AC):
Connect the heater (all types) via a 13 Ampere (or higher) fuse.
- For other countries (220-230 V AC):
Connect types HD 3410 and HD 3411 via a 10 Ampere (or higher) fuse;
Connect type HD 3412 via a 13 Ampere (or higher) fuse.
• If the mains cord of this appliance is damaged, it must only be replaced by Philips or their
service representative, as special tools and/or parts are required.
General description
A
On/off switch: 1st heating element
B
On/off switch: 2nd heating element
C
Thermostat knob
D
Hand grip
E
Vents
F
Radiator
G
Supports
H
Wheels
I
Mains cord
J
Cord storage
(fig. 1) Working
The heating element inside the radiator heats up
the oil.
The warm radiator causes both a natural hot air
flow (convection / heat distribution) and heat
radiance (warm feeling on the skin).
Mounting the supports
For safety: Mount the wheels before using the
appliance.
- Place the heater on the floor upside down
(fig. 2). (It is quite normal if you can hear the oil
moving inside the radiator.)
4