FITTING THE ACCESSORIES
- Unplug the appliance from the mains.
- Push the clamps (D) against the product, move them up and let
them fall near the product so they are untightened.
- Place the Sanding Paper (F) onto the baseplate and fix it with
repeating previos process backwards.
- To remove it, do the first step and after, remove the sanding paper.
DUST COLLECTION SYSTEM: (FIG.1)
- Always use the appliance with the dust collector connected, inhal-
ing dust is harmful to your health.
- Connect the adapter nozzle to the dust suction tank adapter (E).
- Be assured it doesn't fall by moving the appliance.
- To remove the tank, just pull it off.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Assemble the sanding sheet.
- Turn the appliance on, by using the on/off switch.
- Place the appliance against the surface you want to work.
- Slowly move the appliance over the workpiece.
- Do not apply excessive pressure against the workpiece.
- Apply uniform sanding pressure against the workpiece to increase
performance and working life of the sander and the sanding sheet.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated by using the speed
regulator control (B). This function is very useful, as it makes it pos-
sible to adapt the speed of the appliance to the type of work that
needs to be done.
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
- Stop the appliance using the on/off switch.
- Unplug the appliance from the mains.
- Clean the appliance.