HoMedics enviraScape MINI WALL Manual De Instrucciones E Información De Garantía página 4

Fountain Assembly:
1. Place the base on a flat surface.(Fig 3).
2. Insert the light bulb into the light clip located inside the base (Fig 4).
Warning : Bulb gets very hot, allow to cool completely before
touching.
3. Insert the pump outlet into the water tube. The fountain topper should
stand on the base securely (Fig 5).
4. Place the cord through the cord slot on the bottom of the base (Fig 6).
Fig 3
Flat surface
Base
Fig 4
Light bulb
Light clip
Fig 5
Water tube
Pump outlet
5
Fig 6
Cord slot
5. Fill the base with clean water until the water level reaches top of light clip,
and place river rocks on the platform for decoration (Fig 7).
Fig 7
Clean water
Switch
River rocks
6. Plug the cord into 120V household outlet. The fountain is controlled by the
switch located on the power cord, If pump doesn't operate, rotate in-line
switch once to turn" on " and once more turn off.
Note: Ensure that the electrical cord loops below the electrical outlet to form
a "Drip Loop". This will prevent water from
running down the cord into the electrical outlet (Fig 8).
Fig 8
Drip loop
7
Adaptor