Leds Indication - Edimax Fast Cardbus Ethernet Guía De Instalación Rápida

4. Installation
1. Hardware Installation: Hold the Card label up and insert the card into
the notebook PCMCIA / Cardbus slot with 68 pin connector facing the
notebook.
2. Software Installation: The drivers and utilities are supplied by the
CD-ROM included in this product. For a detailed description, please
see the description on the CD Rom.
5. Trouble Shooting
If you are experiencing any problems with the PC Card, first make sure
the appropriate driver is loaded, the proper cable is connected to the PC
card, and the hub is on and working and then check the LED.

6. LEDs indication

1. 10M: When the light is on, it indicates that the 10Mbps connection is
established, when the light is blinking, it indicates that the packets are
transmitting.
2. 100M: When the light is on, it indicates that the 100Mbps connection
is established, when the light is blinking, it indicates that the packets
are transmitting.
1. 10M/100/1000M : When the light is off, it indicates that the 10Mbps
UTP connection is established, when the light is Green, it indicates
that the 100Mbps Fast Ethernet connection is established, when the
light is Amber, it indicates that the 1000Mbps Ethernet connection is
established
2. Link/Activity: The Link/Activity LED indicates the network
connection status, when the light is OFF, it indicates that the
10/100Mbps port has not been connected or linked, when the light is
ON, it indicates that the 10/10Mbps port is connected, when the light
is blinking, it indicates that there is traffic flow on the network which
the adapter is connected to.
EP-4103DL
EP-4203DL
4