Publicidad
Idiomas disponibles
Idiomas disponibles
1. Spread frame apart until fully open on level surface.
2. Unscrew ball knob mounted on reel until 3/8" of thread is showing.
3. Insert pivot axle on frame into elbow.
4. Hold reel in vertical or horizontal position. NOTE: Never face open side of reel when in horizontal position.
5. Tighten ball knob until screw seats in holes of pivot axle. Hand tighten only. Jiggle reel to make sure it is
locked in place.
8. If operating in vertical position, support reel in one hand while loosening ball knob with other hand and
rotate reel into vertical position. Tighten ball knob. Jiggle reel to make sure it is locked in place.
Ball Knob
Hub
Elbow
Manhole : Disassemble unit and pass down frame and reel separately. Loosen ball knob to separate frame
and reel.
Position Horizontally or Vertically: To change position of reel, loosen ball knob approximately 6 turns and rotate
reel around pivot axle. Re-tighten ball knob (hand tighten only).
Feed Rollers: Reset feed rollers by loosening brake handle approximately 1/2", pulling feed roller arm out
toward brace handle and rotating to new position. NOTE: Feed rollers will only engage in two positions -
do not force.
Using The Good Buddy®
Assembly
Leg Assembly
Pivot Axle
Operation
WWW.JAMESONLLC.COM
Clover, SC
Brake Handle
Hub
Feed Guide Assembly
Publicidad
