SLIM COOL
EN
Symptom
• When the unit starts up or runs, the
display
shows
protection).
The
automatically, with the display showing
E9 until the unit has a slant of less than
45º.
• Water is entering the cabin or is filtering
in from outside.
•
The equipment works but does not
cool.
* Suitable machinery must be used whenever it is necessary to extract or introduce
the circuit gas load, respecting the environment at all times.
E9
(compressor
unit
goes
off
22
Cause
• Electronic control or unit slant 45º or
over.
• Valves or wastewater pipes obstructed.
• EPDM seal poorly attached or defective.
• The cabling outputs which protrude from
the lower cover of the blower and coil
cabin are not properly sealed.
•
Too much or too little load in the
circuits.
• Condenser fan terminal inverted.
• Dirt in the capacitor.
• Condenser fan defective.
• Blockage in the circuit.
®