MAINTENANCE
WARNING: Before each use, inspect the
hammer drill, ON/OFF trigger switch, and cord
for any damaged, missing, or worn parts. Check
for loose screws, misalignment or binding of
moving parts, or any other condition that may
affect the operation. If abnormal vibration or
noise occurs, turn the tool off immediately, and
have the problem corrected before further use.
WARNING: Before cleaning or performing
any maintenance, the tool should be unplugged
from the power supply. Using compressed air
may be the most effective cleaning method. Al-
ways wear safety goggles when cleaning tools
with compressed air.
WARNING: Do not let brake fluid, gasoline,
petroleum-based products, penetrating oil,
etc., come in contact with plastic parts. These
substances contain chemicals that can damage,
weaken or destroy plastic.
WARNING: When servicing, use only identi-
cal replacement parts. Use of any other parts
may create a hazard or cause product damage.
WARNING: Use only accessories that are
recommended for the specific model by the
manufacturer. Accessories that may be suitable
for one tool may become hazardous when used
with another tool.
WARNING: Check extension cords before
each use. If damaged, replace immediately.
Never use tool with a damaged cord.
WARNING: To ensure safety and reliability,
all repairs should be performed by a qualified
service technician.
E N G L I S H •
TROUBLESHOOTING
MOTOR DOES NOT START
Tools is not plugged in: Check that all cords are
plugged in.
Fuse: Check the time-delayed fuse or circuit
breaker.
DRILLING IS DIFFICULT
Bit's damaged: Replace the bit.
Wrong bit: Use the proper bit.
U s er 's M an u al
13