Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION SHEET FOR FEDERAL SIGNAL UNISTAT™
Failure to follow all safety precautions and instructions may result in
property damage, serious injury, or death to you or others.
SAFETY MESSAGE TO INSTALLERS, USERS, AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is
to be installed by a trained electrician who is thoroughly familiar with and will follow
all applicable national and local codes.
This device may be considered a part of the signaling system and not the entire
signaling system.
The selection of the mounting location for the device, its controls and the routing
of the wiring is to be accomplished under the direction of the facilities engineer. In
addition, listed below are some other important safety instructions and precautions you
should follow:
•
Read and understand all instructions before installing or operating this
equipment.
•
Do not connect this light to the system when power is on.
•
After installation, ensure that all screws and threaded joints are
properly tightened.
•
After installation, test the light system to ensure that it is operating
properly.
•
After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
•
Establish a procedure to routinely check the light installation for
integrity and proper operation.
I.
GENERAL.
The UniStat™ (USI) is a TYPE 4X with IP66 rating and the UniStat™ (USIS) is
a TYPE 1 status indicator for indoor use that is compact in size. Each UniStat™ status
indicator contains one base, sleeve, PCB, color LED array, lens, cap, and surface gasket.
The cap and sleeve attach to each end of the lens by twist lock joint. Two screws hold
the base and sleeve together. An O-ring between each module provides a water-tight
and dust-tight seal except for the USIS models which has slots to allow audio to emit
from the unit.
A printed circuit board runs the entire length of the base and sleeve of the
UniStat™ status indicator. The printed circuit board contains a terminal block and
circuitry for the control of a color LED array that has an average life of 100,000 hours.
The terminal block provides connection for two input power lines and eight terminals
for setting the operating modes.
STATUS INDICATOR MODEL USI
SAFETY NOTICES
-1-
Publicidad
