BLACK&DECKER GCO182 Manual De Instrucciones página 10

• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the
last part of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce
jamming.
• Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass
which should be drilled dry. The lubricants that work best are sulphurized cutting oil or
lard oil.
• When using twist drill bits to drill holes in wood, it will be necessary to pull the bits out
frequently to clear chips from the flutes.
• Make sure switch turns drill on and off.
DRILLING IN WOOD
Holes in wood can be made with the same twist drill bits used for metal or with spade
bits. These bits should be sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass
which should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil
or lard oil.
DRILLING IN MASONRY
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill
but not so much that you crack the brittle material. A smooth, even flow of dust indicates
the proper drilling rate.
Problem Possible Cause
• Unit will not start. • Battery not installed properly.
• Battery not charged.
• Battery will not charge. • Battery not inserted into charger.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product
SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized service centers or other
qualified service organizations, always using identical replacement parts.
Troubleshooting
10
Possible Solution
• Check battery
installation.
• Check battery charging
requirements.
• Insert battery into
charger until red LED
appears.
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F(4,5°C) or
below105 degree F
(+40,5°C).