Preparation Instructions; Initial Set-Up; Location; Electrical - Mi-T-M THE WORK PRO Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

WARNING

RISK OF EXPLOSION OR FIRE

CAUSING SERIOUS INJURY

OR DEATH!

Do not allow the motor or Motor/

Pressure Switch to come in

contact with flammable vapors,

combustible dust, gases or other

combustible materials. An electric

spark may cause an explosion

or fire.

When using the air compressor

for spray painting, place the air

compressor as far away from the

work area as possible, using extra

air hoses instead of extension

cords.

DANGER

RISK OF ELECTROCUTION!

Improper connection of the

equipment-grounding conductor

can result in a risk of shock

or electrocution. Check with a

qualified electrician or service

personnel if you are in doubt as

to whether the outlet is properly

grounded. This product is factory

equipped with a specific electric

cord and plug based on the units

voltage and amperage rating.

This is for connection to a proper

electric circuit. Only connect

the product to an outlet having

the same configuration as the

plug. Do not use an adapter with

this product. If the product must

be reconnected for use on a

different type of electric circuit,

the reconnection shall be made

by qualified service personnel.

If repair or replacement of the

cord or plug is necessary, do

not connect the grounding wire

to either flat blade terminal. The

wire with insulation having an

outer surface that is green with

or without yellow stripes is the

grounding wire.

WARNING

RISK OF ELECTRICAL SHOCK!

This product must be grounded. If

there should be a malfunction or

breakdown, grounding provides

a path of least resistance for

electric current to reduce the

risk of electric shock.

product is equipped with a cord

having an equipment-grounding

conductor and a grounding type

plug. The plug must be plugged

into an appropriate outlet that is

properly installed and grounded

in accordance with all local codes

and ordinances.

Work Pro Portable Electric Air Compressor Manual

INITIAL SET-UP:

1. Read safety warnings before setting-up air compressor.

2. Ensure the oil level in the air compressor pump is adequate. If low,

add SAE-30W non-detergent oil.

LOCATION:

1. In order to avoid damaging the air compressor, do not incline the air

compressor transversely or longitudinally more than 10°.

2. Place air compressor at least 12 inches away from obstacles that may

prevent proper ventilation. Do not place air compressor in an area:

-where there is evidence of oil or gas leaks.

-where flammable gas vapors or materials may be present.

-where air temperatures fall below 32°F or exceed 104°F.

-where extremely dirty air or water could be drawn into the air

compressor.

ELECTRICAL:

1. USE OF AN EXTENSION CORD IS NOT RECOMMENDED because

it could cause the compressor motor to overheat. It's preferable to use

additional air hose instead of an extension cord.

2. If use of an extension cord is unavoidable, be sure to use one heavy

enough to carry the current your compressor will draw. Minimum cord

sizes is as follows:

Ampere

Rating

Range

120V

240V

8 - 10

10 -12

12 - 14

14 - 16

16 - 18

18 - 20

3. Use only a 3-wire extension cord that has a 3-blade grounding plug and

a 3-slot receptacle that will accept the plug on the compressor.

4. Examine cords before using. Do not use the compressor if its cord is

damaged. Do not use a damaged extension cord.

5. Keep cords away from heat and sharp edges. Do not pull on a cord to

disconnect a plug -- grasp the plug.

6. Always shut off the compressor Pressure Switch before unplugging the

compressor.

This