Maintenance; Troubleshooting - Armor All AA20TI Manual Del Operador

WARNING!
To avoid serious personal injury, always remove the battery pack from the tool when
cleaning or performing maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloth to
remove dirt, dust, oil, grease, etc.
1. Keep the handheld inflator clean and clear of debris. Do not allow foreign material into the
battery port or contacts. Wipe with a dry cloth. Do not use solvents, water, or place in wet
conditions.
2. Always remove the battery pack when not using and before storing the handheld inflator.
3. Keep the handheld inflator stored in normal room temperature. Do not store in excessive heat.
Problem
Motor fails to start when
trigger switch is turned on.
Unit will not start.
Air inflation is weak.

MAINTENANCE

TROUBLESHOOTING

Possible Cause
The battery is not secure.
The battery is not charged.
Defective power switch.
There is a blockage in the hose.
To secure the battery pack,
make sure the latch on the top
of the battery pack snap into
place.
Charge the battery pack
according to the instructions
included with your model.
If within the warranty period
return product to retailer of
purchase.
Check the hose for blockage.
11
Solution