Connecting The Drain Line - LG WM3570HA Serie El Manual Del Propietario

Connecting the drain line

Secure the drain hose in place to prevent moving and
leaking.
NOTE
The drain hose should be properly secured. Failure
y
to properly secure the drain hose can result in
flooding and malfunction.
Total height of the house end should not exceed 96
y
inches (244.8 cm) from the bottom of the washer.
The drain must be installed in accordance with any
y
applicable local codes and regulations.
Make sure that the water lines are not stretched,
y
pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm)
from the end of the drain hose. If the drain hose is
extended more than 4 inches (10 cm) beyond the
end of the elbow bracket, mold or microorganisms
could spread to the inside of the washer.
Elbow bracket
2
Insert the end of the drain hose into the standpipe.
3
Use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
INSTALLATION INSTRUCTIONS
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm)
from the end of the drain hose. If the drain hose is
extended more than 4 inches (10 cm) beyond the
end of the elbow bracket, mold, or microorganisms
could spread to the inside of the washer.
Elbow bracket
2
Hang the end of the drain hose over the side of the
laundry tub.
3
Use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
15