Samsung DV405 Información Técnica página 7

TROUBLE SHOOTING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
No Problem
The igniter does not
8
glow
Igniter glows - No gas
9
ignition
The gas is ignited but
10
the flame goes out
Improper drying
clothes wrinkled
11
Rough texture long
dry time
Noisy and/Or
12
Vibration
(Technical)DV405-02365H-03_EN_130221.indd 7
WARNING
What To Do
If the igniter does not heat up, remove power and using an
ohmmeter, check the following:
•
Open flame sensor
•
Open igniter
• Shorted booster coil
• Open wiring
•
Bad motor switch ( Neutral supply)
•
No power from control ( L1 supply)
If the igniter heats up but the main burner flame is not ignited,
remove power and using an ohmmeter, check the following:
• Open secondary coil
• Open holding coil
•
Open wire harness
•
Stuck flame sensor (Stuck closed)
If a normal ignition takes place and after a short while the flame goes
out, check for the following:
• Radiant sensor contacts opening prematurely.
• Weak gas valve coil may open when stressed by higher Temps.
•
Weak Hi-Limit
•
Poor venting
•
Bad drum seals
•
Lint filter is not clean.
•
Restriction in exhaust.
• Outside exhaust hood damper door stuck closed.
• Exhaust too long, too many elbows, flex ductwork installed.
•
Poor intake air available for the dryer.
•
Incorrect tumbler speed. Tumbler belt slipping.
•
Blower impeller bound; check for foreign material in blower area.
•
Customer overloading dryer.
• Check clothing labels for fabric content and cycle selected.
• Clothes too wet due to insufficient spin out by washer.
• Thumping Check for loose tumbler baffle, rear tumbler roller(s)
worn or misaligned, out-of-round tumbler or high weld seam on
tumbler.
• Ticking Check for loose wire harness or object caught in blower
wheel area.
•
Scraping Check for front or rear bulkhead felt seal out of
position or worn tumbler front bearings.
• Roaring Check for blower wheel rubbing on blower housing or
bad motor bearings.
•
Popping or squealing sound. Check for a sticky or frayed belt.
7
2013-02-21 5:32:00