Descargar Imprimir esta página

Electrical Connection; General Operation - Boss 614UA Manual Del Usuario

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRICAL CONNECTION

a. Make sure your car battery is a 12 volt (6 filler caps) negative ground system (if not, a converter will be necessary).
b. Before starting wiring connections, disconnect the power supply by removing the fuse from fuse box at rear side.
c. Connect the power wire to one of the extra terminals of the fuse box ISO connector harness provided.
d. Connect the black ground wire to a metal part of the car. It is important to make good contact.
e. Make other wiring connections as shown. Plug ISO connector harness to ISO connector and plug fuse to fuse box at
rear side.
f. If your car does not have ISO connector, you can procure it from any car accessory shop.
NOTES: INCORRECT WIRING OR OPERATION WILL AVOID THE WARRANTY OF THIS UNIT .

GENERAL OPERATION

POWER ON/OFF
Press any button to turn on The unit. Long press the knob to turn power off.
AUDIO AND AREA SETTINGS
You can select the following settings by pressing the KNOB ONCE. Rotate it to adjust:
BASS (BAS)-> TREBLE (TRE)-> BALANCE (BAL)-> FADER (FAD)->LOUD(LD ON/OFF)
->EQ (PO/ROCK/CLASSIC/EQ OFF)->BASS (BAS)->DX/LOC->STERO/MONO(STE/MO)
->Frequency Area (USA/EUR)
- LOC / DX MODE
Use this mode to change between Local and Distant (DX) tuning mode. Local mode improves reception in some areas
where the signal is too strong.
- FM MONO / STEREO BUTTON (MONO)
Use this control to select stereo or monaural reception for FM radio stations. You can sometimes improve reception of
distant stations by selecting mono mode.
- CLOCK DISPLAY AND ADJUST
LONG PRESS DISP(SRC)button to display clock. LCD will display clock for 3-4 seconds and then resume to display
current playing status (e.g. Frequency of Radio/AUX/Music information of USB/SD-MMC mode) When LCD is displaying
clock, press DISP(SRC)button and clock digit will flash. Rotate knob to adjust. Press the knob again to switch between
hours and minutes digits. Press DISP(SRC)button to confirm adjusted time.
Fuse Replacement:
To replace the fuse, pull out the blown fuse
from the socket. Insert a new one with same rating,15A
E - 2

Publicidad

loading

Productos relacionados para Boss 614UA