How To Operate - Nostalgia Products HDF510 Instrucciones Y Recetas

Carro para perros calientes de vuelta al mundo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO OPERATE

Before first use, clean the inside of your HOT DOG FERRIS WHEEL CART by
wiping with a moist, non-abrasive sponge, towel or cloth and then wipe
with a non-abrasive dry towel. Wipe down the Carousel and Carousel Cradles
and be sure it is properly placed in the brackets before starting.
1.
Find a flat surface near an electrical outlet, and ensure
the cord is away from any water source.
2.
Gather your hot dog making supplies: hot dogs, buns, condiments, serving tongs, etc.
3.
Make sure the Carousel is properly secured in the support brackets.
4.
Plug in the appliance while all Control Switches are flipped to the OFF position.
5.
Turn the Power Light to the ON position.
NOTE: Power Light must be in the ON position in order
for the unit to heat or rotate the Carousel.
6.
Place a hot dog in each Cradle. Toggle the Rotate switch in order to reach the Cradles in the
back of the unit.
7.
If desired, place hot dog buns into the Warming Compartment.
8.
To cook hot dogs, toggle the Heat switch to HIGH and the Rotate switch to ON.
9.
Allow the hot dogs to cook. You will notice the color begin to darken as
the hot dogs are cooking. The time required to cook the hot dogs will vary,
depending upon the size and starting temperature of the hot dogs.
10. When ready to serve, flip the Rotate switch to OFF, then use a tongs or fork to remove hot
dogs from Carousel Cradles. Toggle the Rotate switch to rotate the Carousel and reach the
hot dogs at the back of the unit.
CAUTION: Unit will be HOT when serving. Take care to avoid touching the
Carousel and Cradles, as well as the Heating Elements located on the ceiling
and back of the unit. An oven mitt may be used to avoid burns.
11. Keep remaining hot dogs warm by flipping the Heat switch
to WARM and the Rotate switch to ON.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido