Publicidad
ENGLISH
OPERATING INSTRUCTIONS
Ensure air mover is in a safe operating location. Do not
place machine in a puddle and make sure it is protected
from drips and splashes.
Plug the power cord into a grounded electrical outlet.
Always unwind power cord completely before operating
machine. Inspect power cord for damage before each use.
Replace cord immediately if damaged.
Place the machine in the desired operating position
Horizontal – dry floors and carpets (Fig. 1)
Tilted – dry floor finishes, paint, etc. (Fig. 2)
Vertical – dry wall and ceiling (Fig. 3)
Set the desired speed by turning switch
Check for proper operation before leaving the machine
unattended. Do not move or carry the machine when it is
operating.
To shut-off machine, turn the switch to the
OFF (O) position (Fig. 4).
The machine is equipped with an automatic reset motor
overload shut-off thermal sensor to protect motor from
overheating. Should the shut-off thermal sensor trip, it will
reset automatically when the motor has cooled sufficiently,
usually after 15-30 minutes.
MACHINE COMPONENTS
A. 3-Speed Switch
B. Carrying Handle
C. Power Cord Storage
Fig. 1
4
(Fig. 5)
D. Air Outlet Vent
E. Air Intake Vent
F. Kick Stand
Fig. 2
Fig. 3
Fig. 4
MACHINE MAINTENANCE
To keep machine in good working condition, simply
perform the following maintenance procedures.
WARNING: Unplug cord from outlet when not in use and
before servicing machine.
• Inspect power cord for damage after each use. Replace
power cord immediately if damaged.
• Clean machine with a damp cloth.
• Check for dust accumulation around the air inlet and
outlet vents and clean if necessary. Blocked vents will
cause the motor to overheat, and may lead to premature
failure. Warranty claims for this type of damage will not
be accepted.
If machine fails to operate:
• Check power cord for damage.
• Check plug connection.
• Check building circuit breaker.
• Thermal sensor shut-off – wait 15-30 minutes to cool.
• Contact service center.
STORING AND TRANSPORTING
AIR MOVER
Neatly wrap power cord and store machine in a cool dry
area. Do not expose to rain, store indoors. Stack machines
for storage as shown (Fig. 6).
CAUTION: Do not stack beyond four high. Do not stack
during transporting and secure with strap.
Telescoping handle and wheels
are included with SC6057
To use, push in release button, pull handle up until it locks
into place. Tilt the machine back onto the wheels and roll
to desired location.
B
A
D
F
Fig. 5
C
Fig. 6
E
Publicidad
