BOERBOEL GardDog Instrucciones De Instalación página 3

Mounting The Latch To The Post
1
a.) Once hinges are installed and gate is aligned, place
the front latch template at desired height at the
edge of the post closest to the gate. Be sure to line
up the edge if the template to the edge of the post.
Bend and af x the 2 legs of the template to the
inside of the post (Fig. 1).
b.) Place the rear latch template to the edge of the rear
of the post, ensuring the template legs overlap the
legs of the front template (Fig. 2).
c.) Pre-drill the top and bottom holes using a
bit on front and rear templates (Fig. 3).
d.) Pre-drill the two larger holes using a
front and rear templates (Fig. 3).
e.) Remove and discard templates.
NOTE:
• When using a solid post, if it isn't possible to
drill completely through the post, keep the drill
perpendicular to the post and drill at least
halfway through the front and rear sides to
ensure proper alignment of the holes.
• The push rod and square lock rod are pre-
measured for you, according to your size,
and takes into account the push button and
latch measurements. Only cut the rods at the
pre-measured marks.
e.) Cut the push rod and square lock rod using a
hacksaw on the pre-measured marks for your post
size (Fig. 4).
f.) Insert the cut square lock rod into the grooves of
the lock cavity on the rear push button (Fig. 5).
⁄ ⁄ ⁄ ⁄ " drill
3 3 3
32 32
⁄ ⁄ ⁄ ⁄ " drill bit on
5 5 5
8 8
Front of Front of
Post Post
Legs Legs
Rear of Rear of
Post Post
Legs Legs
Template Template
3/32" 3/32"
3/32" 3/32"
Rear Push Button Rear Push Button
Lock Cavity Lock Cavity Lock Cavity
Fig. 1
Template Template
Fig. 2
Fig. 3
5/8" 5/8"
5/8" 5/8"
Fig. 4
Fig. 5
Cut Square Cut Square
Lock Rod Lock Rod Lock Rod Lock Rod
3