Panasonic TY-ST20-K Istrucciones De Instalación página 11

Assembly Procedure
2. Install the Plasma Display
Place the assembled pedestal with the rear side (side with the model nameplate attached) facing towards
yourself, align the plasma display with the stand poles, insert the stand poles into the plasma display, and insert
and tighten the unit installation screws
(Tightening torque: 1.5 to 1.8 N•m)
Rear of Plasma Display
Model Nameplate
With the side that has the model nameplate
attached facing you, insert the stand poles as
far as possible into the plasma display.
3. Connecting Additional Equipment and the Power Cord
For details on wiring connections, see the instruction manual of the plasma display.
Connect the necessary wiring for the additional equipment, pass a clamper
rear of the stand base, and bunch together all of the cords and cables as shown in the diagram.
Do not bunch the power cord together with other cords and cables.
Rear View
Clip
Clamper
Cables
(Cont'd)
(4 screws).
While ensuring there is sufficient slack in the cord to minimize stress,
firmly bind cables with the supplied clamper
Binding the Cables
Pass the tip of the clamper
through the clip
Rear of Plasma Display
Unit installation screw
(1 clamper) through the clip on the
.
Unbinding the Cables
Pull
Pull
Bundle
all cables
tidily
Pull the lock
section of the
clamper
11