PROGRESS LIGHTNING AirPro P2539 Manual página 11

Installing the Light Kit
Pan/Light Kit Fitter
Assembly/ Shatter-
Resistant Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 13)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 13)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit fitter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 14)
4. Push the light kit fitter assembly up so
that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter
assembly clockwise, tightened the screws.
Re-install the screw that was removed in
step 3 and tighten firmly. (Figure 14)
5. Place the shatter-resistant bowl into the
light kit pan, aligning the three flat areas
on the top of the shatter-resistant bowl with
the three raised dimples in the light kit pan.
Turn the shatter-resistant bowl clockwise
until it stops. (Figure 15)
PERIODICALLY CHECK THE SHATTER-
RESISTANT BOWL IS SEATED FULLY
CLOCKWISE IN THE LIGHT KIT PAN
ASSEMBLY.
Light Kit
Pan
Mounting
Screw (3)
Screw (3)
Plastic
Shade
Figure 13
Molded
Adaptor Plugs
Figure 14
Raised
Dimples
Flat Area
Figure 15
8.