Allen-Bradley 6181 Instrucciones De Instalación página 14

14
6181 Industrial Computer
Panel Mounting with Mounting Studs
To install the 6181 Computer in a panel using 8 mounting studs:
ATTENTION: Disconnect all electrical power from the
panel before making cutout.
Make sure the area around the panel cutout is clear.
Take precautions so that metal cuttings do not enter any
components that are already installed in the panel.
Failure to follow these warnings may result in personal
injury or damage to the panel components.
1. Cut an opening in the panel using the appropriate panel cutout
dimensions provided on pages 11 or 12. Carefully drill eight 6.4 mm
(0.25 in.) holes for the mounting studs as indicated.
2. Make sure the sealing gasket is properly positioned on the terminal.
This gasket forms a compression type seal (NEMA Type 4). Do not
use sealing compounds.
3. Place the 6181 Computer in the panel cutout aligning the studs with
the mounting holes.
4. Install the 8 self-locking nuts hand tight.
Publication 6181-IN002C-MU-P