Mounting Main Enclosure Assembly - Touchboards peerless FPECMI-01 Instalación Y Ensamblaje

Mounting Main Enclosure Assembly

• Do not lift more weight than you can handle. Always use an assistant or mechanical lifting equipment to safely lift
and position the fl at panel screen.
• Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to
40 in. • lb (4.5 N.M.) maximum torque.
Hook tilt plate (B) onto bottom socket screws
10
threaded into adapter box (A) and select desired
tilt angle (0° to 20°) as shown in fi gure 10.1.
NOTE: Be sure split lock washer (F) is on outside
of tilt plate as shown in detail 2.
Insert two M10 x 16 mm socket screws (E) and
two split lock washers (F) through tilt plate (B) and
into top of adapter box (A) as shown in fi gure 10.2.
Tighten all fasteners using 6 mm allen wrench.
CAUTION
• Do not allow main enclosure assembly to hang freely
on wall box (A) when all four sets of M10 x 16 mm
socket screws (E) are not fully secured or mount may
come off of wall.
WARNING
E
fi g 10.2
7 of 24
All other brand and product names are trademarks or registered trademarks of their respective owners.
MAIN ENCLOSURE
ASSEMBLY
B
fi g 10.1
ISSUED: 08-09-10 SHEET #: 061-9059-4 10-18-10
© 2010, Peerless Industries, Inc. All rights reserved.
A
B
F
DETAIL 2