Clock Setting; Heating Mode - TESY HPWH 2.1 200 U02 Manual De Usuario

2. Clock setting

Clock setting:
- After switching the appliance on, press
flash together;
- Press button to switch hour/minute setting, press the
- Press button again to confirm and exit.

3. Heating mode -

Press and hold the button
display will look like:
The left side of the temperature display
display shows the current temperature of the water tank.
The heat pump will start working continuously in order to reach the set temperature. If the set temperature is adjusted
o
to above 65 C, E-Heater will start working to continue heating the water to the set temperature.
If the outside air temperature is less than -10
While the heat pump is working at a low outside air temperature, defrosting mode could be activated automatically in
order to melt the ice collected on the evaporator. This is a normal situation.
4. Setting desired water temperature
During running status, press
The maximum achievable water temperature by heat pump only, depends on outside air inlet temperature and
could be seen on picture:
If the set temperature (via control display) is more than achievable one as per picture, the E-heater will be switch ON
automatically to reach it.
button to entry the clock setting interface, hour and minute icons "88:88"
and
for 2 seconds when the unit is in standby. The "Heating mode" will start. The
shows the set water temperature. The right side of the temperature
o
C or above 44
or button to adjust the set temperature of water tank directly.
Page 4 of 71
buttons to set the exact hour(s) and minute(s);
o
C, the E-Heater will work only!