General Washing Techniques; Shut Down Procedures - Landa ZF Serie Manual Del Operador

ZF SERIES PRESSURE WASHER
GENERAL WASHING
TECHNIQUES
1. Hold spray nozzle approximately one foot from the
surface being cleaned. Spray at an angle to get un-
der the material and lift it off.
2. When washing large objects, use detergent injector
to apply detergent. Start washing the bottom and
work up. Let detergent set for 5-10 minutes for faster
results and better detergent economy. After wash-
ing, rinse from the top down.
3. Cleaning heavy dirt or material away with a hard
stream of clear water is recommended before using
a cleaning agent.

SHUT DOWN PROCEDURES

1. Rinse all lines (and injector) with clean water to re-
move any soap residue.
2. Turn motor off.
3. Turn off water supply.
4. Open spray gun to relieve remaining pressure.
5. Remove water supply hose.
6. In freezing conditions, disconnect water supply and
open spray gun to allow water to drain, then turn off
motor.
CAUTION: Do not allow pump to run longer than 5
minutes without water. Disconnect all hoses and al-
low water to drain.
LANDA ZF • REV. 9/02
OPERATOR'S MANUAL 7