Taurus ALPATEC MF3000 Manual Del Usuario página 15

- The appliance is not suitable for outdoor use.
- Supply cord should be regularly examined for
signs of damage, and if the cord is damaged,
the appliance must not be used.
- Do not use or store the appliance outdoors.
- Do not touch the plug with wet hands.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not remove the support feet of the appliance.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- This appliance is for household use only, not
professional, industrial use.
- Store this appliance out of reach of children and/
or persons with physical, sensory or reduced
mental or lack of experience and knowledge.
- Keep the appliance in a dry, dust-free place, out
of direct sunlight.
- Make sure that dust, dirt or other foreign objects
do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or jam-
med and make sure there are no broken parts
or anomalies that may prevent the appliance
from operating correctly.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry pets or animals.
- Do not use the appliance to dry textiles of any
kind.
SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
A Propeller
B Grill
C Nebulizer
D Fan stick
E Nebulizer tube
F Control Panel
F.1 Timer
F.2 Velocity Selector
F.3 Mist Selector
G Water Tank
H Body
I Wheel Base
J Oscillation Selector
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- Do not remove the support feet or wheels from
the appliance.
- Ensure that the appliance is level with respect
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base
ASSEMBLING THE BASE (FIG. 3)
3.1 Base
3.2 Wheels
- Fit the base on the main body of the appliance.
- Fix the base using the screws provided
- Stand the appliance up again so as to check
that the base works properly.
Assembling the wheels:
- Fix the wheels by pressing onto the base, as
shown in figure 3.
ASSEMBLING THE GRILL AND THE PROPE-
LLER: (FIG.4)
- Fit the rear grill (4.2) on the motor housing (4.1),