Publicidad
3
Mount the Wall Plate
Solid concrete or concrete block
3-1
Mark the wall
[01]
3-2
Drill pilot holes
3-3
Insert anchors and lag bolts
[06]
[06]
8
Level the wall plate [01] and mark the hole locations.
CAUTION:
Mount the wall plate [01] directly onto the concrete surface.
Minimum solid concrete thickness: 8 in.
Minimum concrete block size: 8 x 8 x 16 in.
Drill pilot holes as illustrated.
CAUTION:
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a
10 mm (3/8 in.) diameter drill bit.
Never drill into the mortar between blocks.
75 mm
(3 in.)
Insert lag bolt anchors [06]. Then insert lag bolts [04] through the
wall plate [01] and into the anchors.
CAUTION:
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
[01]
[05]
[04]
13 mm
(1/2 in.)
Avoid potential injuries or property damage!
Avoid potential injuries or property damage! :
Avoid potential injuries or property damage!
Be sure the anchors [06]
are seated fl ush with the
concrete surface.
Tighten the lag bolts [04]
only until the washers
[05] are pulled fi rmly
against the wall plate
[01].
DO NOT over-tighten
the lag bolts [04].
10 mm
(3/8 in.)
6902-002023 <02>
Publicidad
