Weston 61-0201-W Manual Del Usuario página 5

SETUP
NOTE: Check that all parts are operating properly, and
perform the intended functions. Check for alignment of
moving parts or any other conditions that may affect
the operation. If the product is not working properly,
contact Customer Service.
DO NOT attempt to grind bones, nuts, or foods not
prepared to a soft texture. Grinding other food than
what food mill was intended for will void the warranty.
1. Unplug.
2. Select a milling disc for desired recipe and
consistency.
3. With food bowl secure on a countertop, insert
selected milling disc, dome side up, into food
bowl, aligning disc with the shape of the bottom of
food bowl. (FIGURE 1)
4. Insert auger shaft into hub of base with auger
facing away from base to avoid food bowl scraper.
(FIGURE 2)
5. Holding auger assembly in place, insert auger
assembly pin into center hole of milling disc.
(FIGURE 3)
6. Align base with food bowl locks and push down
until it clicks and base locks into place on food
bowl. (FIGURE 3)
7. Align lid over bowl and base.
8. Secure lid in place with lid latches, making sure
latch on lid is aligned with safety interlock switch.
Plug in to operate. (FIGURE 4)
To Disassemble:
1. Unplug before disassembling. Place food mill on a
counter. Unlatch and remove lid.
2. While holding food bowl with one hand, place
thumb into center of food bowl release. Pull food
bowl release straight out until food bowl releases.
3. Lift base up to remove from bowl.
4. Remove auger assembly and disc.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
5