Descargar Imprimir esta página

Important - Airhogs ZERO GRAVITY LASER Guía De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

WHILE DRIVING YOUR ZERO GRAVITY™ LASER
1
1. Stand within 2 metres (6 feet) of the wall.
3
3. Make sure to point the laser beam within 33 cm
(1 foot) radius of the vehicle.
5
5. Only drive on smooth, clean, dry surfaces. Make
sure surfaces are clear of obstacles, including
hanging pictures, light switches, etc...
7
7. LED light on top of the Zero Gravity™ Laser will
be solid ON when the battery power is good.
TROUBLESHOOTING
CONTROLLER GUIDING MULTIPLE VEHICLES:
Any ZERO GRAVITY™ LASER controller can control a ZERO GRAVITY™ LASER
vehicle (red or blue) as long as the 'laser' is within 33 cm (1 foot) of the vehicle.
When racing two vehicles, to prevent interference, do not race within 33 cm of
each other.
SPIN MASTER LTD.
225 KING STREET WEST, TORONTO, ON M5V 3M2 CANADA
Imported into EU by :
SPIN MASTER INTERNATIONAL, B.V., Kingsfordweg 151, 1043 GR Amsterdam, The Netherlands
www.spinmaster.com
Imported by Spin Master Australia Pty Ltd, 18-24, Suite 101, Level 1, Chandos Street, St Leonards, NSW 2065;
1800 316 982
MADE IN CHINA
TM & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future reference. Children should be
supervised during play. Keep away from obstacles and electrical hazards. Spin Master Ltd. reserves the right to discontinue the
www.airhogs.com website at any time.
T44366_0052_20119378_GBL_IS_R5
T44366_0054_20119573_GBL_IS_R5
< 2 m
2
2. Do not drive off the corner or off the
edge of the wall.
4
4. Do not point the laser beam outside a 33 cm
(1 foot) radius of the vehicle, or the vehicle will
not respond.
6
6. Do not drive on uneven, porous, or broken
surfaces, as vehicle will not adhere and can fall
off.
8
8. IMPORTANT: When the LED begins to blink, the
battery is running low on power. Car should be
removed from the wall immediately. Otherwise
the vehicle may fall off the wall.
FAN DOES NOT TURN ON:
If the fan does not turn on when the ZERO GRAVITY™ LASER'S power switch is
in the WALL position, turn the vehicle off and check for debris trapped in the vents
under the vehicle. Remove any dust/debris and fully charge the ZERO GRAVITY™
LASER before trying again.
NOTE: Not a real laser beam. Light beam visible on surfaces, not in the air.
CAUTION: Do not shine bright lights into eyes. Direct viewing of bright lights may impair vision.
a WARNING: CHOKING HAZARD - Small parts. Not for children under 3 years.
2

Publicidad

loading