Selecting A Location; Locking The Safe - STACK-ON TD-40-SB-B-S Instrucciones

OPENING THE SAFE USING
YOUR FINGERPRINT
To open the safe, press the scanner with a recorded
nger. e blue light will come on with one beep (if
the sound is turned on) and the scan will begin.
If the green light ashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted and
you will have 5 seconds to turn the handle to open
the door.
If the red light ashes once, the scanner did not read
your ngerprint and you must try again. If the red
light ashes 3 times, the scanner read your ngerprint
and did not accept it.
If there are 3 rejected scans, where your
ngerprint was read, and the red light ashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again.
safe will beep one time (if the sound is turned
on) and the green light will ash once when the
lockout period is over.
If there is 1 more rejected scan where your
ngerprint was read and the red light ashes 5 times
with 5 beeps (if the sound is turned on), you will
have an automatic lockout for 5 minutes before you
can try a scan again.
the sound is turned on) and the green light will ash
once when the lockout period is over.

LOCKING THE SAFE

To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
e
e safe will beep one time (if
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound turned on.
To turn the sound o , press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.
ELECTRICAL OUTLET
e safe has a UL Listed interior electrical outlet
that can be connected to an exterior 110V-15A
power source only.
Install the exterior power cord into the electrical
outlet in the back of the safe.
NOTE: For easy access, install the power cord
before securing the safe to the oor.

SELECTING A LOCATION

e safe must be mounted to the oor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
e safe should be at against the wall and oor.
Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
4
20
40676-1605