Publicidad
NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED
KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND
The WLAN Access Point 2332-E1 and related Series 2332 access points communicate with a Nortel Networks WLAN -
Security Switch using a standard CAT-5 (Category 5) or higher 10/100 Mbps twisted pair Ethernet cable to provide
wireless local area networking (WLAN) capabilities. The WLAN Access Point 2332-E1 and related Series 2332 access
points include one 802.11a and one 802.11b/g radio and two 802.11a and two 802.11b/g omnidirectional internal
antennas. In addition, the 2332-E1 and related Series 2332 access points can use optional factory-supplied external
omnidirectional and/or directional high-gain antennas, one per the 802.11b/g and one per the 802.11a radios, as
described in the external antenna section of the WLAN Series 2332 Access Point Installation Guide. When using the
external antennas, connect them to the reverse-polarity R-SMA connectors located on the side of the WLAN 2332-E1 or
related Series 2332 Access Point.
Declaration of Conformity
Marking by this symbol
indicates compliance with the Essential Requirements of the R&TTE Directive of the European Union (1999/5/EC).
This equipment meets the following conformance standards:
Safety: EN 60950-1:2001 + A11:2004
EMC: EN 55022:2006, EN 55024:1998 + A1:2001 + A2:2003, EN 301-489-1 v1.6.1, EN 301-489-17 v1.2.1,
CISPR22:1997, CISPR24
Including: EN 61000-3-2, -3-3, -4-2, -4-3, -4-4, -4-5, -4-6 and -4-11. The product is also licensed as required for
additional country specific standards as required for the International Marketplace.
Radio: EN 300-328 v.1.7.1 (2006-10) & EN 301-893 v.1.4.1 (2007-07)
DEVIATION: The 2332-E1 and related Series 2332 access points were tested to and are compliant with all of the
technical specifications of EN 301-893 v1.4.1 for operation in the 5.0 GHz bands, except the DFS requirements in
the 5600 – 5650 MHz band.
IEEE 802.11a operation in the 5250 to 5350 MHz and 5470 to 5725 MHz frequency bands is governed by ETSI EN
301-893 v1.4.1 and the R&TTE Directive 1999/5/EC. Effective July 1, 2008, EN 301-893 v1.4.1 was updated to
require compliance with 0.8 µsecond pulse widths and staggered PRF's in the 5470 – 5725 MHz band. The 2332-E1
access point meets compliance with these new mandates by disabling operation, via software, on channels 120, 124,
128 and 132 in the 5600 to 5650 MHz frequency band because it cannot meet the 0.8 µsecond pulse width and
staggered PRF DFS requirements as outlined in the updated EN 301-893v1.4.1 standard.
Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband transmission systems; Data
transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation techniques and
Broadband Radio Access Networks (BRAN); 5 GHz high performance RLAN. Certifications are harmonized to the
EN standards covering essential requirements under article 3.2 of the R&TTE Directive. Compliance includes
testing with antennas as specified in attached table.
SAR: EN 50385:2002
!
Nortel WLAN—Series 2332 Access Points Quick Installation
5
Publicidad
Capítulos
