Operation; First Time Use; Replacing The Battery - HAMPTON BAY 1000 020 912 Guía De Uso Y Cuidado

Assembly (continued)
3
Mounting to a rail
Align the rail mount adapter (E) onto the selected rail.
Use a pen or pencil to trace the two holes onto the rail
and remove the rail mount adapter (E).
Pre-drill pilot holes onto the rail where your pen/pencil
marks were made.
Insert plastic anchors (CC).
Insert screws (BB) through the rail mount adapter (E)
and the pilot holes in the rail. Tighten until secure.
Firmly slide the light and post mount assembly
(A, B, C and D) on top of the rail mount adapter (E) until
it is flush.
Insert screws (AA) through the holes on the sides of the
post mount (D) and rail mount adapter (E). Tighten
until secure.
NOTE: If post is wooden, you will not need to
insert plastic anchors.

Operation

1

First time use

Remove the light head (A) from the shade (C).
Remove the pull tab (1) in between the battery and its
connector.
The solar light needs to charge in full sunlight for 8 - 12
hours to allow the rechargeable battery to reach
maximum capacity. For optimum performance, allow
the battery to charge in full sunlight.
2

Replacing the battery

Remove the light head (A) from the shade (C).
Remove the lens (B) from the light head (A).
Press the release tab. Pull up and remove the battery
cover (F).
Remove the old battery and replace with a new lithium
phosphate 3.2V, 600 (14500) mAh rechargeable battery.
Return the battery cover (F).
Return the lens (B) to the light head (A).
Return the light head (A) to the shade (C).
1
A
5
Please contact 1-855-HD-HAMPTON for further assistance.
AA
D
BB
CC
B
E
F
HAMPTONBAY.COM