Adapting Microwave - Hotpoint RVM1535DMCC Instrucciones De Instalación

B4.

ADAPTING MICROWAVE

BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
3 Carefully slide the blower motor toward the right,
and lift it partially out of the opening. Note: The
blower wires are long enough to allow flexible
handling while performing these steps. Disconnect
the wires only if it is necessary for additional
flexibility.
4 Remove the two screws holding the gray-colored
inlet sleeve to the blower unit. Rotate the gray
sleeve as shown until the gray arrow lines up with
the "B", back exhaust. Reinstall the two screws.
Remove screws from
Gray Inlet Sleeve
Roll the assembled blower unit so that the
5
black-colored exhaust outlet faces the back of
the microwave and the gray-colored inlet sleeve
faces downward. NOTE: The gray-colored sleeve
opening must ALWAYS face downward to ensure
proper operation of the microwave.
Must Face
Downward
Installation Instructions
Back of
Microwave
Back of Microwave
Black
Exhaust
Outlet
Back of
Microwave
6 Tilt and place the blower unit back into the
opening in the top of the microwave.
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
7 Secure the blower unit to the microwave with
the two screws removed in Step 2.
Retaining
screw
8
Close the blower cover.
9
Attach the exhaust adaptor to the rear of the
microwave by sliding it into the guides at the
top center of the back of the oven.
Adaptor
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings freely. Reinstall the original
blower motor screw through the adaptor and
into the back of the microwave.
17
Retaining
screw
Back of
Microwave
Guide
Blower Motor Screw
Locking Tabs