Safety Agency Compliance Statements; Safety Precautions; Modifications To Equipment; Placement Of A Sun Product - Sun Microsystems Sun StorEdge T3 Manual De Instalación

Safety Agency Compliance
Statements
Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Sun Microsystems product.

Safety Precautions

For your protection, observe the following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
I
equipment.
Ensure that the voltage and frequency of your power
I
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
I
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in the product
documentation:
Caution – There is risk of personal injury and
equipment damage. Follow the instructions.
Caution – Hot surface. Avoid contact. Surfaces
are hot and may cause personal injury if
touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
On – Applies AC power to the system.
Depending on the type of power switch your device has,
one of the following symbols may be used:
Off - Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.

Modifications to Equipment

Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.

Placement of a Sun Product

Caution – Do not block or cover the openings
of your Sun product. Never place a Sun
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
Caution – The workplace-dependent noise
level defined in DIN 45 635 Part 1000 must be
70Db(A) or less.
i