Indoor Motion Activated
Light Control Instructions
This light control automatically turns a light on when motion is detected in the room and off 10
minutes after you leave. Senses activity at distances up to 30 feet away when mounted 8 feet from
floor, with a detection zone up to 120°. Perfect for laundry room, garage, basement or attic because it
eliminates the need to fumble in the dark for a switch or pull-string.
FOR INDOOR USE ONLY
Caution: This motion sensor is not designed for use with an enclosed or shaded fixture of any kind.
Infrared cannot penetrate glass or plastic. Use only with a ceiling mounted, bare bulb light socket.
Works with any compact fluorescent or incandescent bulbs, 75 Watts Max. Do not use with
halogen bulbs.
DIRECTIONS FOR USE:
• Turn power to light socket off.
• Remove the light bulb from socket.
• Screw the Motion Activated Light Control into the
empty socket.
• Screw the light bulb into the Motion Activated
Light Control.
• Position the motion sensor window to face the
entryway to the room or area of activity.
• Turn the power on. After a few seconds, the light
will turn on. The light will turn off 10 minutes after
you leave the area.
• The unit will now operate automatically.
LIMITED WARRANTY
Under normal use and conditions, AmerTac provides to the original purchaser of this product a one
year limited express warranty that is set forth in the Limited Warranty stated in full at
www.amertac.com/warranties. The Limited Warranty is in lieu of all other express or implied
warranties or liabilities subject to the exceptions explained fully in the Limited Warranty on the
website. Prop 65 WARNING: This product contains chemicals known in the State of California to
cause cancer and birth defects or other reproductive harm.
AmerTac
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China
© 2017 AmerTac™
I17-0029-A
Light socket
Portalámpara
Douille de lampe
Motion Sensor
Sensor de
movimiento
Détecteur de
mouvement
120V~, 60Hz, 75 Watts Max
MLC2BC
3154847