Publicidad
Step 7
B
C
A
Step 8
L
M
T
Step 9
Install the LOWER wall plate (A) using the remaining three large flat washers
(B) and lag screws (C). Position lower wall plate as pictured at left. Using a 1/2"
socket wrench, install the lag screws (C) through the large washers (B) into the
wall plate (A). It is important that all three lag screws are used and tightened
down. Use the level to insure the wall plate is secured in a level vertical plane.
Δ Caution: Over tightening the lag screws (C) may break off the lag screw
head.
Locate the shelf brackets (M) and threaded slide plates (L). Loosely install the
1/4-20 x 3/8" button head allen screws (O) through the shelf bracket (M) and into
the threaded slide plate (L). DO NOT TIGHTEN (FIG 1). Slide shelf bracket (M)
and slide plate (L) assembly onto support tube assembly previously assembled
in STEP #2 (FIG 2). Position shelf bracket assembly (L)/(M) in approximate loca-
tion on support tube assembly. Secure button head allen screws (O) using allen
wrench (S) to prevent shelf bracket assembly from moving.
Repeat procedure in STEP 8 for remaining two shelf bracket assemblies
(L)/(M)
TIP: If your power source is below or above shelf system, you must feed single
power cord through the wall plate (A) prior to installation of support tube assem-
bly (STEP 10).
FIG 1: Install plastic wall plate covers (K) on top and bottom of support tube/
Step 10
bracket assembly. Slip assembly up through upper wall plate. Assembly must
go upward far enough into upper wall plate to allow support tube to engage
into lower wall plate bracket.
FIG 2: Place the plastic pin ring (D) with slotted end upward onto top end of
support tube. Insert retaining pin (E) through the holes in the top end of sup-
port tube.
FIG 1: The support tube/bracket assembly can be lowered allowing the retain-
Step 11
ing pin (E) to engage into slots in plastic pin ring (D). Once this is done, slide
the plastic wall plate cover (K) into position over the top wall plate and snap
into place.
FIG 2: Slide the lower wall plate cover (K) into position over the bottom wall
plate (A) and snap into place.
Publicidad
