Technoblock XR75CH Manual Del Usuario página 5

HOW TO CHANGE A PARAMETER VALUE
To change the parameter's value operate as follows
1. Enter the Programming mode by pressing the
Released the keys, then push again the
displayed immediately followed from the HY parameter.
NOW YOU ARE IN THE HIDDEN MENU.
2. Select the required parameter
3. Press the
4. Use or
5. Press to store the new value and move to the following parameter.
To exit: Press +
NOTE: the set value is stored even when the procedure is exited by waiting the time-out to expire.
per key to display its value
to change its value
, or wait 15s without pressing a key.
+ keys for 3s (the
+ keys for more than 7s. The Pr2 label will be
LED starts blinking).