Publicidad
Idiomas disponibles
Idiomas disponibles
7.3 When you store the heater, let it cool down first, keep it dry. Then cover it with a plastic bag, put
in a packing box and store it in a dry, ventilated place.
8. Trouble shooting:
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service center.
Problem
Possible cause
The heater does not
The plug is loose, bad
operate, even when
connection
it is plugged in and
the switch,
No power in socket outlet
thermostat are
switched on.
The heating
The input voltage is too high
element glowing
or too low
The air inlet grill is blocked
The switch was not put at
heating setting
The thermostat operated
The appliance
didn't heat up, only
ventilator worked
The self-setting cut-out
operated
Abnormal noise
The appliance does not
stand upright
Disposal
Environmental Protection
Waste electrical production should not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local Authority or retailer for recycling
advice.
Treatment
Pull out the plug, check the
connection of the plug and
socket. Then connect again.
Insert the plug in a proper
socket
Use power supply according
to the rating on the label
Keep the heater far away from
articles like curtain, plastic
bag, paper and other things
which can cover the inlet or
can be easily cover on the air
inlet
Turn the switch to heat setting
Turn the thermostat and listen
if there is open/close noise. If
there is no click and the
thermostat is not damaged,
the heater will automatic
switch on when the appliance
cooled down
Turn the heater off and
inspect the blockage of inlet
or outlet. Disconnect the
plug and wait at least 10
minutes for the protection
system to reset before
attempting to restart the
heater.
Put the heater on a level
surface
Publicidad
