Tabla de contenido
Publicidad
SELECTING THE TEMPERATURE
• To change the temperature selection, press the temperature button (3.6);
you can increase the temperature position by pressing the selection increase
button (3.8). If a position higher than 1 is selected, you can reduce the
temperature position by pressing the selection reduction button (3.9).
• To confirm your selection, press the temperature button again (3.6) or else it
confirms automatically after a few seconds. The temperature that corresponds
to the selected temperature position appears on the screen when you confirm
the selection (3.2).
• There are 4 temperature positions that correspond to the following tem-
peratures:
– Position 1: 30ºC
– Position 2: 35ºC
– Position 3: 40ºC
– Position 4: 45ºC
• However, these temperatures are approximate and may vary slightly while
the appliance is in use.
SELECTING THE OPERATING TIME
• When the appliance is switched on, the time selected by default before the
product switches off automatically is 6 hours. You can reduce this time by
pressing the timer button (3.7) and then the selection reduction button (3.9).
You can also increase the time before the appliance switches off automati-
cally by pressing the timer button (3.7) and then the selection increase
button (3.8).
• These buttons (3.8 and 3.9) increase or decrease the time by one hour in a
range of 1 to 10 hours.
• Your selection will be confirmed after a few seconds without modifying the
selection or by pressing the timer button again (3.7).
• When you confirm the selection, the selected time appears on the screen
(3.5) and the time starts to count down one hour at a time; this also appears
on the screen (3.4).
• Once the selected time has passed, the appliance stops heating up, the
screen shows the FF symbol and the light on the control flashes until any
button is pressed.
• If any operating error is detected or the power cord is not properly con-
nected to the product, the screen shows the ER symbol and the light
flashes. Make sure the cord is properly connected, switch off the control and
switch it back on.
• The light of the screen is blue; it comes on while the control is being used
and switches off automatically after 5 seconds. If you want it to light up
again, press the selection increase button 3.8 or the selection reduction
button 3.9.
Calientacamas CT8640-8645 11
11
4/1/07, 13:45:21
Publicidad
Tabla de contenido
