Foppapedretti Babyroad Serie Manual De Uso página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
Your Group 1-2-3 booster seat
(2)
1. Adjustable headrest
2. Harness straps (x2)
3. Back
4. Diagonal belt guide (x2 – use with harness)
GB
5. Seat
6. User guide pocket (if fitted on this model)
7. Crotch strap
8. Harness buckle
9. Adjustment strap (x2)
10. Body insert (if fitted on this model)
11. Adjustor (x2)
12. Safety cover (x2)
13. Diagonal belt guide (x2 – used without the harness)
Assembling the booster seat
Place both tongues on the back into the notches on the seat (3), and then raise the
back up vertically (4).
Press firmly on the back to ensure that both tongues of the back of the seat are
securely in place (5). The tongues on the back must be pushed down as far as they
will go into the seat.
Installation with the harness
Gr. 1, from 9 to 18 kg (from approximately 9 months to 4 years)
Make sure that the harness of your car seat is adapted to the height of your child
before starting to install the seat in your car.
The harness can be adjusted to three different heights. The straps must pass
through the holes that are closest to your child's shoulders. If your child's shoul-
ders are between two levels, always use the higher of the two. To adjust the height
of the harness, remove the upper section of one of the harness straps by twisting
the metal keeper located behind the backrest
(6)
and then pulling the end of the
harness strap through the slots of the shell and the cover (7). Feed the end of the
harness strap through the same slots at the desired height, both in the cover and
the shell
(8)
and reattach it behind the backrest (9). Make sure that the metal
anchor is correctly positioned and that the end of the harness strap is not twisted.
Repeat the operation on the second strap.
To tighten the harness: Pull on the adjusting straps positioned on the harness.
You do not need to press on the adjuster buttons (10).
To loosen the harness: Press on the adjuster buttons positioned on the upper sec-
tion of the harness, grasp the lower section and pull simultaneously (11). Press on
the red harness button on the buckle to free your child completely.
Place the car seat against the back seat of the vehicle (12). Lower the headrest as
14
GB - User guide

Publicidad

Tabla de contenido
loading

Tabla de contenido