D-Link DWL-P200 Guía De Instalación Rápida página 4

Connecting The DWL-P200
Connect another Cat 5 Ethernet cable from the Base Unit "P+DATA OUT"
to the "P+DATA IN" of the Terminal Unit.
Use Voltage Selector to set DC output to 5V/2.5A or 12V/1A as required
by the Network Device.
Only use a CAT 5 Ethernet straight-through cable.
Insert one end of the DC Power Cable that is provided into the Terminal
Unit, and the other end into the DC of the Network Device. The Power
LED of the Terminal Unit should light up.
4