BRONDI SD-10 Manual Del Usuario página 10

EN
SETTING THE UNIT TO ANSWER-ONLY MODE (No Incoming Messages will be recorded).
Make sure the OGM2 is recorded. Press the ON/OFF button once (OGM will play and 2 short beeps
will be heard). Press the ON/OFF button again and the unit will emit 3 short beeps and then play
OGM2.
The message counter and "Ao" will then alternate in the display indicating the unit is in Answer-
Only mode.
SETTING THE UNIT TO THE ANSWER-OFF MODE
Press ON/OFF button unitl "--" appears in the display to set the unit to the Answer off mode.
SETTING THE RINGS
The amount of times the phone rings before picking up can be set to 2, 3, 4 or Toll-Saver. Toll saver
will answer the call on the fourth ring if no messages have been recorded and it will answer on the
second ring if new messages have been recorded; this feature is useful when phoning in for your
messages.
Press and hold the RING/ ◄◄ button for 2 seconds; the unit will beep and the present.
Press the Ring/ ◄◄ button and/or CODE/ ◄◄ button to change the ring setting. When the desired
ring setting appears, press the STOP button. To check the current ring setting, press and release
the RING/ ◄◄ button;
To record a personal memo which will be played the next time somebody retrieves the messages,
press and hold the MEMO button for approximately 2 seconds; a beep will sound and the
countdown timer will appear in the display. The recording time of the memo must be less than 30
seconds and more than 3 seconds.
After the message is recorded, release the MEMO button to stop the recording. To hear the memo,
simply play back the messages by pressing the Play/Pause button.
SCREENING YOUR CALLS
Adjust the VOLUME control on the side of your unit to hear the caller and press the SPKMONI
button until "on" appears in the display.
When a call is received, you may listen to the caller leaving an incoming message. If you wish to
speak with the caller, just pick up the handset to talk (the machine will turn off automatically). Press
the SPKMONI button again until "OF" appears in the display to turn the call screen screening off.
PLAYING BACK INCOMING MESSAGES (ICMS)
The display's message counter will blink when the unit has recorded new messages. If the message
counter is not blinking, then that is the number of messages that have been recorded previously,
but not deleted.
To hear messages, proceed as follows:
Make sure the VOLUME control is adjusted as desired.
If new messages have been recorded, press the Play/Pause button to hear only the new messages.
If no new messages have been recorded, press the Play/Pause button to hear the previously heard
messages that were not deleted.
After playing the messages, the display's message counter will show the total messages received.
NOTE: Messages will automatically be saved. To delete messages, see page 9.
To repeat a message while you are listening to it, simply press the RING/ ◄◄ button. Repeatedly press
this button to skip back to previous messages.
To skip a message while you are listening to it, press the CODE/ ◄◄ button and the next recorded
message will play.
To pause the ICMS, press and release the Play/Pause button, the unit will pause playback and "PA"
3