Unpacking ........................................................... 3
Gas Supply .......................................................... 4
Ventilation ............................................................ 4
Installation ........................................................... 4
SAFETY INFORMATION
WARNING: This product
contains and/or generates
chemicals known to the State
of California to cause cancer or
birth defects or other reproduc-
tive harm.
WARNING: Fire, burn, in-
halation and explosion hazard.
Keep solid combustibles, such
as building materials, paper or
cardboard, a safe distance away
from the heater as recommended
by the instructions. Never use
the heater in spaces which do or
may contain volatile or airborne
combustibles or products such
as gasoline, solvents, paint thin-
ner, dust particles or unknown
chemicals.
WARNING: Not for home or
recreational vehicle use.
WARNING: Do not exceed
1/2 psi (14" w.c.) gas pressure
to the gas control valve.
The heater is designed for use as a construction heat-
er in accordance with ANSI Z83.7/CGA 2.14. Other
standards govern the use of fuel gases and heating
products for specific uses. Your local authority
can advise you about these. The primary purpose
of construction heaters is to provide temporary
heating of buildings under construction, alteration
or repair. Properly used, the heater provides safe
economical heating. Products of combustion are
vented into the area being heated.
2
TABLE OF CONTENTS
www.desatech.com
Storage ................................................................ 7
Specifications ...................................................... 7
Illustrated Parts Breakdown and Parts List ....... 10
We cannot foresee every use which may be made of
our heaters. Check with your local fire safety au-
thority if you have questions about heater use.
Carbon Monoxide Poisoning:
more affected by carbon monoxide than others.
Early signs of carbon monoxide poisoning re-
semble the flu, with headaches, dizziness and/or
nausea. If you have these signs, the heater may not
be working properly. Get fresh air at once! Check
for proper ventilation and have heater serviced.
Natural and Propane/LP Gas:
pane/LP gas is odorless. An odor-making agent is
added to these gases. The odor helps you detect
a gas leak. However, the odor added to the gas
can fade. Gas may be present even though no
odor exists.
Make certain you read and understand all warn-
ings. Keep this manual for reference. It is your
guide to safe and proper operation of this heater.
1. Install and use heater with care. Follow all
local ordinances and codes. In the absence
of local ordinances and codes, refer to the
Standard for Storage and Handling of Liq-
uefied Petroleum Gas, ANSI/NFPA 58 and
the Propane Installation Code, CAN/CGA
B149.2. This instructs on the safe storage and
handling of flammable gases.
2. Use only the hose and factory preset regulator
provided with the heater.
3. Model 125-R: Use only propane gas set up
for vapor withdrawal. Model 125-RN: Use
only natural gas.
4. Provide adequate ventilation. Before us-
ing heater, provide at least a 0.28 m
opening of fresh outside air for each 100,000
Btu/Hr rating of heater [0.35 m
125,000 Btu/Hr heaters].
5. For indoor use only.
6. Do not use heater in occupied dwellings or in
living or sleeping quarters.
7. Do not use heater in basement or below ground
level.
Some people are
Natural and pro-
(3 ft
)
2
2
(3.75 ft
) for
2
2
114248-01C