Brandson Equipment 302391 Manual Del Usuario página 15

5 Initial use
Take the device out of the package and remove all the packaging material. Insert a
"CR2032" battery (not included in the scope of supply) into the battery compart-
ment which is located at the bottom. Pay attention to the correct polarity of the
contacts. This battery is used for saving a backup of the time and date.
Press the "Previous station" key to alternate between the time display and the
date display. Press the "Projection ON/OFF" key to switch the projection on or off
in a flexible manner.
6 Setting the time and date
Once the device is connected to an appropriate socket, press and hold
the "M+/NAP/SET/MEM" key to set the time and date. Use the "Next
station" and "Previous station" keys to increase or decrease the dig-
its. Once again, press "M+/NAP/SET/MEM" to continue with the settings.
The setting cycle is as follows:
1. Year
2. Month / Day
3. 12/24 Hours
4. Hour / Minute
Note: To enable the summer time (DST), press and hold the "Snooze/Sleep/Dimm/
DST" key in the Standby mode.
7 Setting the alarm
Press one of the two "Alarm" keys to display the wake-up time. Press and hold the
key once again to go to the alarm settings. To do this, once again press the "Next
station" and "Previous station" keys to set the alarm. The setting cycle is as follows:
15
English