ENGLISH
designed and manufactured to meet IP68 specification for total protectionagainst water and
dust intrusion.
This quick guide provides a basic guide for the operation of your radio.
Attaching and removing accessories
To attach an accessory, remove the accessory cover by unscrewing the locking screw anti-
clockwise (leave cover attached or store in a safe place).
Plug the accessory into the socket, then carefully tighten the locking screw clockwise until
finger tight (do not over tighten or use any implement).
To remove an accessory, unscrew the locking screw of the accessory by hand in an anti-cloc-
kwise direction.
Ensure you re-fit the accessory socket cover (the radio is not submersible without the socket
covered).
Battery charging
1. Connect the AC adapter to the charger pod and plug in.
2. Turn the radio off.
3. Insert the battery pack into the charger pod, either with or without the radio attached. The
charger LED status light changes to red and charging begins.
4. When charging is complete the charger LED status changes from red to green. A fully dis-
charged battery pack will take approximately 3 hours to recharge.
A flashing red LED on the charger indicates there is a problem with the battery.
Remove the battery from the charger and consult your the manufacturer.
8
INTRODUCTION
OPTIONAL ACCESSORIES
BATTERY INFORMATION